LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500L Trekking >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Column >> Wheel, Steering >> Removal

Wheel, Steering: Removal

WARNING:
  • Do not place a non-deployed airbag face down on a hard surface. The airbag will propel into the air if accidentally deployed. Failure to follow this instruction may result in possible serious or fatal injury.
  • Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. This will disable the airbag system. Failure to follow this instruction may result in accidental airbag deployment and possible serious or fatal injury.
  • Allow the airbag system capacitor to discharge for two minutes before removing the steering wheel or any airbag system component. Failure to follow this instruction may result in accidental airbag deployment and possible serious or fatal injury.
GC0158654Courtesy of CHRYSLER GROUP, LLC
  1. Adjust the steering wheel (1) so that the tires are in the STRAIGHT-AHEAD position.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the driver airbag (2). Refer to AIR BAG, DRIVER, REMOVAL .
  4. Disconnect the wiring harness connectors at the clockspring.
    CAUTION:

    Do not bump or hammer on the steering wheel or steering column shaft when removing the steering wheel.

    CAUTION:

    Do not attempt to rotate the clockspring rotor once the steering wheel is removed. The clockspring must remain centered in its travel to avoid overextending the clockspring inner parts, causing the clockspring to become inoperative. If removed and handled properly using the correct procedures, it should remain in the "centered" position. If there is any question as to whether the clockspring is in the "centered" position of travel, perform the clockspring centering procedure before installing the steering wheel.

    GC0158594Courtesy of CHRYSLER GROUP, LLC
  5. Remove steering wheel nut cap, if equipped.
  6. While holding the steering wheel firmly in place, remove the nut (1) that secures the steering wheel to the steering column shaft.
  7. While holding the steering wheel firmly in the STRAIGHT-AHEAD position, remove the steering wheel from the steering column shaft splines.
  8. If necessary remove the steering wheel mounted radio controls. Refer to SWITCH, REMOTE RADIO, REMOVAL .