LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 124 Spider Lusso, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Pump, Water >> Removal And Installation >> Water Pump >> Installation

Water Pump: Installation

  1. If necessary, use a suitable tool to remove the sealant residues from the water pump.
    GC0175653Courtesy of CHRYSLER GROUP, LLC
  2. Apply a strip of silicone sealant to the contact surfaces between the water pump and the engine block.
    GC0175774Courtesy of CHRYSLER GROUP, LLC
  3. Position the water pump (1a) and install the screws (1b) and the nut (1c). Tight to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Install the timing belt guard and bolt in its housing, Securely tighten the bolt.
  5. Install the timing belt. Refer to BELT, TIMING, REMOVAL AND INSTALLATION .
  6. Fill the cooling system. Refer to STANDARD PROCEDURE .
  7. Install the right and left rear half of the wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
  8. Install the belly pan. Refer to BELLY PAN, ENGINE, REMOVAL AND INSTALLATIONBELLY PAN, FRONT, REMOVAL AND INSTALLATION .
  9. Remove support and lower the vehicle.
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals