Diagnostic Test

CARRY OUT DATA CONFIGURATION
1. Go to key-off condition.
2. at least 1 minute.
3. at least 3 seconds.
4. Go to key-on condition (engine off or on).
  DIAG_QUESTION_NOT_AVAILABLE
  
  Yes
  - YES_STATEMENT_NOT_AVAILABLE
  No
  - NO_STATEMENT_NOT_AVAILABLE
CHECK FOR PRESENCE OF ELECTRIC POWER STEERING (EPS) MODULE ERRORS
1. Connect the diagnosis equipment and carry out the Electric Power Steering (EPS) Module error deletion procedure.
2. Check whether the error is still present.
  Is the error still present?
  
  Yes
  - Repeat the checks from Step 1.
  - If the error occurs again, move on to Step . Refer to 3.
  No
  - End of diagnosis.
CHECK FOR PRESENCE OF INSTRUMENT PANEL CLUSTER (IPC) ERRORS
1. Check for presence of Instrument Panel Cluster (IPC) errors.
  Are errors present?
  
  Yes
  - Use the Instrument Panel Cluster (IPC) diagnosis to resolve, then configure the Panel.
  No
  - Go to Step 4.
CHECK THAT THE ELECTRIC POWER STEERING (EPS) MODULE IS WORKING PROPERLY
1. Carry out the Electric Power Steering (EPS) Module error deletion procedure.
2. Check whether the error is still present.
  Is the error still present?
  
  Yes
  - Repeat the checks from Step 1.
  - Replace the Electric Power Steering (EPS) Module if the error occurs again.
  No
  - End of diagnosis.