When Monitored

WARNING: This page is about a different variant/trim than selected.

This monitor runs continuously when the following conditions are met:
The ignition switch is ON.
The system voltage is greater than 10.2 Volts.
The Transmission Control Module (TCM) is not operating in a diagnostic service mode.
Ignition line voltage is greater than 10.5 Volts for 500 ms.
Linear Solenoid feedback current is less than a calibrated value.
The TCM is not operating in a Limp Home mode.
Linear Solenoid short to Voltage, short to ground or open circuit faults are not detected.