Removal And Installation

REMOVAL 

1. Disconnect and isolate the negative battery cable.
2. Remove the soft top side housing lining. (Refer to CONVERTIBLE TOP ).

   Courtesy of CHRYSLER GROUP, LLC

3. Disconnect the wire harness connector (1).
4. Remove the screw (2a) and remove the keyless entry receiver (2b).

INSTALLATION 

1. Position the keyless receiver to the vehicle and tighten the screw.
2. Connect the wire harness connector.
3. Install the soft top side housing lining. (Refer to CONVERTIBLE TOP ).
4. Connect the negative battery cable.