LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2016 >> 500L Easy, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 ((Transmission Control Module (TCM) - Electrical Diagnostics, Aw60T/6F25 Automatic Transmission - 500L)) >> DTC Troubleshooting >> P0713-00-Transmission Fluid Temperature Sensor A Circuit High >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.
  1. CHECK IF DTC IS CURRENT 
    1. Using the scan tool, read TCM DTCs.
    2. Record the Environmental Data and any DTCs.
    3. Clear DTCs.
    4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    5. Read TCM DTCs.

      Did the DTC reset?

      Yes 

      • Go To 2

      No 

      • Go To  3
  2. CHECK THE TRANSMISSION TEMPERATURE SENSOR 
    Fig 1: Checking Transmission Temperature Sensor
    GC0154201Courtesy of CHRYSLER GROUP, LLC
    TYPICAL VALUES FOR TRANSMISSION TEMPERATURE SENSOR
    TEMPERATURE  APPROXIMATE OHM 
    -30° C (-22° F) 44000 Ohms ± 6600
    10° C (50° F) 6455 Ohms ± 645
    110° C (230° F) 247 Ohms ± 16
    145° C (293° F) 111 Ohms ± 6
    1. Measure the resistance of the Transmission Temperature Sensor between the Transmission Temperature Signal circuit and the Transmission Temperature Sensor Ground circuit in the appropriate terminal of the TCM transmission connector.
    2. Using the chart at the chart above, compare the Temperature Sensor temperature to the correlating resistance value.

      Is the resistance within the specified range when the sensor is at the given temperature?

      Yes 

      • Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL, REMOVAL .
      • Perform the AW60T VERIFICATION TEST. Refer to AW60T TRANSMISSION VERIFICATION TEST  .

      No 

      • Remove the Transmission Side cover and inspect the internal harness for an open or short to B(+) in the Transmission Temperature sensor signal circuit. Refer to VALVE BODY, REMOVAL . If no open or short is found, replace the Transmission Temperature sensor.
      • Perform the AW60T VERIFICATION TEST. Refer to AW60T TRANSMISSION VERIFICATION TEST  .
  3. CHECK WIRING AND CONNECTORS 
    1. The conditions necessary to set the DTC are not present at this time.
    2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
    3. Wiggle the wires while checking for shorted and open circuits.
    4. Check for any Service Bulletins that may apply.

      Were there any problems found?

      Yes 

      No 

      • Test Complete.
scientia non olet · About LEMON Manuals