Diagnostic Test
- CHECK FOR RELATED DTCS
- Turn the ignition on.
- With the scan tool, read Body Control Module (BCM) DTCs.
Are there any communication DTCs present?
Yes
- Refer to the DTC INDEX - 500E and perform any communication diagnostic procedure before proceeding.
No
- Go To 2
- CHECK IF THE DTC IS ACTIVE
- Turn the ignition on, vehicle in run mode.
- Turn the A/C on to max cold.
- Wait a minimum of 60 seconds.
- With the scan tool, read Electric Vehicle Control Unit (EVCU) DTCs.
Is the status for this DTC Active?
Yes
- This DTC is an informational DTC that will set if the EVCU receives a message over the Can Bus showing no Electric Compressor RPM when a request was sent. For EAC diagnostics, refer to the DTC INDEX - 500E .
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .