Diagnostic Test
- CHECK IF THE DTC RESETS
- Turn the ignition on.
- With the scan tool, erase EVCU DTCs.
- Turn the ignition off. Remove the key from the Ignition Switch, close doors and allow the EVCU to shut down.NOTE:
Allow up to two minutes for the EVCU to shut down. Opening the vehicle door will interrupt the shut down process.
- Turn the ignition on.
- With the scan tool, read EVCU DTCs.
Does this DTC reset?
Yes
- Refer to the DTC INDEX - 500E and perform the appropriate diagnostic procedure for speed control switches.
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .