Aw60T Transmission Verification Test

For a complete wiring diagram, refer to appropriate SYSTEM WIRING DIAGRAMS article  .

1. 1. Perform the following after completion of a diagnostic repair:
      1. Reconnect any disconnected components.
      2. Connect the scan tool to the Data Link Connector (DLC).
      3. With the scan tool, erase all Transmission and Engine DTCs.
      4. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
      5. Check the Transmission fluid level and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
      6. With the scan tool, perform the TCM Quick learn procedure if a transmission component has been replaced, or the TCM has been replaced or flashed. Perform AW60T TCM Quick Learn.
      7. Road test the vehicle allowing the vehicle to shift through all gears.
      8. Check for DTCs during and after the road test.

      Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

      Yes 

      • Refer to DIAGNOSIS AND TESTING  and perform the appropriate diagnostic procedure.

      No 

      • Repair is complete.