Diagnostic Test

CHECK TRANSMISSION CONFIGURATION IN THE POWERTRAIN CONTROL MODULE (PCM)
1. Using a scan tool, view the configuration in the PCM.
  Does the PCM configuration indicate manual transmission as present?
  
  Yes
  
  NOTE:
  The most likely cause of this DTC is the PCM has been replaced and flashed with the wrong software. Once the PCM configuration is set, it cannot be changed. A new PCM will be required.
  - Replace and program the PCM in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL [EAF], REMOVAL or MODULE, POWERTRAIN CONTROL [EAB], REMOVAL or MODULE, POWERTRAIN CONTROL [EAJ], REMOVAL .
  - Perform the AW60T VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Clear TCM DTCs and retest. If the PCM configuration indicates automatic transmission as present, and the TCM resets this DTC, replace and program the TCM. Refer to MODULE, TRANSMISSION CONTROL [EAJ], REMOVAL or MODULE, TRANSMISSION CONTROL [EAB], REMOVAL .
  - Perform the AW60T VERIFICATION TEST. Refer to STANDARD PROCEDURE .