LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2013 >> 500 Abarth >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) Except 500E >> Standard Procedure >> Program The Pcm (Powertrain Control Module)

Program The Pcm (Powertrain Control Module)

  1. Connect the scan tool.
  2. Check vehicle for DTCs.
  3. Clear all stored DTCs.
  4. Turn car OFF then ON and confirm DTCs are gone.
  5. Refer to MODULE REPLACEMENT AND PROGRAMMING ORDER GUIDE  and perform the PCM/ECM PROGRAMMING procedure.

If required, continue to programming the next module.

scientia non olet · About LEMON Manuals