LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2012 >> 500 Pop, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 ((Transmission Control Module (TCM) - Electrical Diagnostics)) >> Standard Procedure >> Aw60T Transmission Verification Test >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.
  1. Perform the following after completion of a diagnostic repair:
    1. Reconnect any disconnected components.
    2. Connect the scan tool to the Data Link Connector (DLC).
    3. With the scan tool, erase all Transmission and Engine DTCs.
    4. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
    5. Check the Transmission fluid level and adjust if necessary. Refer to STANDARD PROCEDURE for the Fluid Fill procedure.
    6. With the scan tool, perform the TCM Quick learn procedure if a transmission component has been replaced, or the TCM has been replaced or flashed. Perform AW60T TCM Quick Learn.
    7. Road test the vehicle allowing the vehicle to shift through all gears.
    8. Check for DTCs during and after the road test.

    Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

    Yes 

    No 

    • Repair is complete.
scientia non olet · About LEMON Manuals