Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK TRANSMISSION CONFIGURATION IN THE POWERTRAIN CONTROL MODULE (PCM)
- Using a scan tool, view the configuration in the PCM.
Does the PCM configuration indicate manual transmission as present?
Yes
- Replace and program the PCM in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL [EAB], REMOVAL .
- Refer to STANDARD PROCEDURE and perform the AW60T VERIFICATION TEST .
NOTE:The most likely cause of this DTC is the PCM has been replaced and flashed with the wrong software. Once the PCM configuration is set, it cannot be changed. A new PCM will be required.
No
- Clear TCM DTCs and retest. If the PCM configuration indicates automatic transmission as present, and the TCM resets this DTC, replace and program the TCM. Refer to MODULE, TRANSMISSION CONTROL [EAB, DF1], REMOVAL .
- Refer to STANDARD PROCEDURE and perform the AW60T VERIFICATION TEST .
- Using a scan tool, view the configuration in the PCM.