Test 68C - Fuel Gauge/Lamp Operation

WARNING: This page is about a different car, the 1997 Eagle Vision, 1997 Dodge Intrepid, 1997 Chrysler LHS, and 1997 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Perform TEST 68A before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION . For wiring schematics, see WIRING DIAGRAMS in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE after each repair.

CAUTION: Always turn ignition off prior to disconnecting any module connector.

Gain access to Body Control Module (BCM). Turn ignition off. Disconnect BCM connectors. Turn ignition on. Go to next step.
Using scan tool in voltmeter mode, measure voltage at terminal No. 22 (Red/White wire) on BCM Bone connector. If voltage is 10 volts or less, repair open Red/White wire. If voltage is more than 10 volts, replace BCM.