Park/Neutral Switch: Installation
- Install park/neutral switch with bolts loosely installed. Install manual control lever. Install and tighten manual control lever bolt to specification. See TORQUE SPECIFICATIONS . Install shift cable on manual control lever with nut on cable loosely installed.
- To adjust park/neutral switch, place shift lever in Neutral. Rotate park/neutral switch so hole end of manual control lever aligns with hole in body on park/neutral switch. See Fig 1.
- Tighten park/neutral switch bolts to specification. Ensure park/neutral switch does not move when tightening the bolts. Lightly pull end of shift cable toward manual control lever and tighten nut on shift cable. Note park/neutral switch terminal identification. See Fig 2.
- Using ohmmeter, check that continuity exists between designated terminals in relation to shift lever position. See PARK/NEUTRAL SWITCH CONTINUITY table. If continuity is not as specified, readjust park/neutral switch.
PARK/NEUTRAL SWITCH CONTINUITY
| Shift Lever | Terminal No. |
|---|---|
| Park | 3 & 4; 7 & 8 |
| Reverse | 2 & 3; 5 & 6 |
| Neutral | 3 & 12; 7 & 8 |
| Drive | 3 & 10 |
| 2 | 3 & 11 |
| Low | 3 & 9 |