LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1996 >> Talon Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Non-Turbo >> Trouble Code Tests >> Test TC-96A - No CCD Messages From TCM

Test TC-96A - No CCD Messages From TCM

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  Directory. For wiring diagram, see WIRING DIAGRAMS article.
  1. Turn ignition on. Using scan tool, select TRANSMISSION. Using scan tool, select 41TE. CCD BUS test is automatic. If scan tool displays BUS OPERATIONAL, go to next step. If scan tool does not display BUS OPERATIONAL, refer to the BODY CONTROL COMPUTER TESTS article in the ACCESSORIES/SAFETY EQUIPMENT section. Perform TEST VER-2A.
  2. Using scan tool, select ENGINE module. Using scan tool, erase trouble codes. Raise and support vehicle so all wheels are off the ground. Start engine. Put transmission in Drive and allow drive wheels to rotate for one minute. Apply brakes. Put transmission in Park. Using scan tool, read trouble codes. If scan tool displays NO CCD MESSAGES FROM TCM, go to step 4). If scan tool does not display NO CCD MESSAGES FROM TCM, go to next step.
  3. Condition to set trouble code is not present at this time. Inspect all related wiring and connectors and repair as necessary. If no problems were found with wiring and connectors, see test procedures under INACTIVE TROUBLE CODE CONDITION . Test is complete. Perform TEST VER-2A. If related wiring and connectors were repaired, perform TEST VER-2A.
  4. Turn ignition off. Disconnect Transmission Control Module (TCM) connector. See TRANSMISSION CONTROL MODULE (TCM) LOCATION  table. Using scan tool in voltmeter mode, check voltage on TCM connector terminal No. 3 CCD BUS + circuit (Black/Dark Blue wire). If voltage is more than 2 volts, go to next step. If voltage is 2 volts or less, repair open CCD BUS + circuit. Perform TEST VER-2A.
  5. Using scan tool in voltmeter mode, check voltage on TCM connector terminal No. 44 CCD BUS - circuit (White/Dark Blue wire). If voltage is more than 2 volts, replace TCM. Perform TEST VER-2A. If voltage is 2 volts or less, repair open CCD BUS - circuit. Perform TEST VER-2A.
TRANSMISSION CONTROL MODULE (TCM) LOCATION

Application Location
Talon Under Center Console In Front Of Shift Lever
scientia non olet · About LEMON Manuals