LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1996 >> Summit ES, 1.8 C >> Repair and Diagnosis >> Engine Performance >> Engine Controls - Adjustments - 1.8L 4-CYL >> Throttle Position (TP) Sensor >> TP Sensor Adjustment >> Summit Wagon

Summit Wagon

  1. Disconnect TP sensor connector. Using external ohmmeter, measure resistance between TP sensor terminals No. 1 and 2. Insert .025" (.65 mm) feeler gauge between fixed speed adjusting screw and throttle lever.
  2. Loosen TP sensor mounting screws and rotate TP sensor fully clockwise. Ensure there is continuity between terminals No. 1 and 2. Rotate TP sensor counterclockwise until there is no continuity and tighten screws. Install Test Harness (MB991348 ) between TP sensor and harness connector.
  3. Turn ignition on. Using external voltmeter, measure TP sensor output voltage between terminals No. 1 and 3. If voltage is not .4-1.0 volt, check harness and sensor. See SYSTEM/COMPONENT TESTS - 1.8L 4-CYL article.
    Fig 1: TP Sensor/APS Connector Terminal ID (Mirage, Summit & Summit Wagon)
    G93I78137Courtesy of MITSUBISHI MOTOR SALES OF AMERICA
scientia non olet · About LEMON Manuals