Door Lock Actuator
- Access left front or right rear door lock actuator. Refer to DOOR LOCK ACTUATOR
under REMOVAL & INSTALLATION. Disconnect harness connector. Set actuator in LOCK position. Connect positive lead of 12-volt power source to terminal No. 1 of actuator. See Fig 1
. Actuator should move to UNLOCK position when terminal No. 3 is connected to negative lead.
- With the actuator set in the UNLOCK position, connect positive lead of 12-volt power source to terminal No. 3 of actuator. See Fig 1
. Actuator should move to LOCK position when terminal No. 1 is connected to negative lead.
- Access right front or left rear door lock actuator. Refer to DOOR LOCK ACTUATOR
under REMOVAL & INSTALLATION. Disconnect harness connector. Set actuator in LOCK position. Connect positive lead of 12-volt power source to terminal No. 3 of actuator. See Fig 1
. Actuator should move to UNLOCK position when terminal No. 1 is connected to negative lead.
- With the actuator set in the UNLOCK position, connect positive lead of 12-volt power source to terminal No. 1 of actuator. See Fig 1
. Actuator should move to LOCK position when terminal No. 3 is connected to negative lead.
- On left or right door lock actuator, there should be continuity between terminals No. 2 and 4 when actuator is in UNLOCK position. There should be no continuity in LOCK position. Replace actuator if it fails any preceding tests.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.