Test 8D - Bus Short To 5 Volts
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see appropriate article in ENGINE PERFORMANCE:
- WIRING DIAGRAMS - 3.3L
- WIRING DIAGRAMS - 3.5L
- After each repair, perform TEST VER-1.
CAUTION:
Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
Using scan tool in ohmmeter mode, check traveler module connector ground circuit. If resistance is more than 5 ohms, repair open in Black or Black/Dark Green wire. If resistance is less than 5 ohms, replace traveler module.