LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1995 >> Summit DL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - Tests W/Codes - OBD-I (1.8L)) >> Diagnostic Tests >> Code 61: Transaxle Control Module Signal

Code 61: Transaxle Control Module Signal

WARNING: This page is about a different variant/trim than selected.
NOTE: For component terminal identification, see the TERMINAL IDENTIFICATION  in this article. For appropriate WIRING DIAGRAMS, see WIRING DIAGRAMS  section.
  1. Disconnect Transaxle Control Module (TCM) and PCM connectors. Ground TCM connector terminal No. 7 (No. 18 on Expo and Summit Wagon). Using DVOM, check continuity between chassis ground and PCM connector terminal No. 116. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  2. Ground TCM connector terminal No. 9 (No. 4 on Expo and Summit Wagon). Check continuity between chassis ground and PCM connector terminal No. 59. If continuity does not exist, repair wiring harness as necessary. If continuity exists, go to next step.
  3. Ground TCM connector terminal No. 108 (No. 17 on Expo and Summit Wagon). Check continuity between chassis ground and PCM connector terminal No. 7. If continuity does not exist, repair wiring harness as necessary. If continuity exists, test is complete. Intermittent problem may exist. See TESTS W/O CODES - 1.8L article.
scientia non olet · About LEMON Manuals