Test 4B - Repairing Instrument Cluster Printed Circuit Board
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
. Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector.
- Using DRB, stop test. Turn ignition switch to OFF position. Remove and inspect inoperative lamp. Replace lamp If necessary. If lamp is okay, go to next step.
- Inspect instrument cluster printed circuit board. Replace printed circuit board if necessary. If printed circuit board is okay, repair or replace instrument cluster. See INSTRUMENT PANEL article in ACCESSORIES/SAFETY EQUIPMENT section.