Test 8F - Short To 5 Volts

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Using DRB in ohmmeter mode, check resistance of ATC head connector terminal D7 (Black wire). If resistance is more than 5 ohms, repair open Black wire. If resistance is less than 5 ohms, replace ATC head.