LH Body

If problem is with trunk release or warning light, go to TEST 36E of the appropriate TESTS W/CODES - BODY CONTROL COMPUTER article in the ENGINE PERFORMANCE section. See following list. If problem is not with trunk release or warning light, ensure DRB-II door lock test is still active. Disconnect Remote Keyless Entry (RKE) module Black connector. Module is located on top, right side of dashboard.
- TESTS W/CODES - BODY CONTROL COMPUTER (for 1992)
- TESTS W/CODES - BODY CONTROL COMPUTER (for 1993)
  NOTE: RKE module may be accessed by carefully prying each end of dashboard top cover, then lifting rear edge of top cover and sliding cover forward to disengage front clips.
With DRB-II in voltmeter mode, check voltage on RKE Black connector door unlock relay feed circuit (Pink/Violet wire). If voltage fluctuates from zero volts to less than 10 volts, repair open circuit in Pink/Violet wire. Perform VERIFICATION PROCEDURE VER-1 .
If voltage fluctuates from zero volts to more than 10 volts, use DRB-II to stop door lock test. With DRB-II in ohmmeter mode, check resistance on RKE Black connector ground circuit (Black wire). If resistance is less than 5 ohms, replace RKE module. Perform VERIFICATION PROCEDURE VER-1 . If resistance is more than 5 ohms, repair open circuit in Black wire. Perform VERIFICATION PROCEDURE VER-1 .