LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1990 >> Premier ES >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnosis & Testing >> DRB-II Test Functions >> DRB-II Volt-ohmmeter Mode

DRB-II Volt-ohmmeter Mode

  1. To access volt-ohmmeter mode of DRB-II, connect Red  volt-ohmmeter test lead to Red  port, located on top right side of DRB-II.
    NOTE: Because DRB-II is grounded through diagnostic connector, only one volt-ohmmeter test lead is required when using volt-ohmmeter option. DRB-II volt-ohmmeter should only be used when required by diagnostic flow charts.
  2. To access voltmeter, press VOLT/OHM key once. DRB-II is now in voltmeter mode. Touch test probe to connector or wire to be measured. Read voltage on DRB-II display. When voltage testing is complete, press VOLT/OHM key 3 times to exit voltmeter mode.
  3. To access ohmmeter, press VOLT/OHM key twice. DRB-II is now in ohmmeter mode. Touch test probe to connector or wire to be measured. Read resistance to circuit ground on DRB-II display. When resistance testing is complete, press VOLT/OHM key twice to exit ohmmeter mode.
scientia non olet · About LEMON Manuals