Sensor, Knock: Installation: 5.7L

Thoroughly clean the knock sensor mounting hole.
Install the knock sensor (1) into the cylinder block.
NOTE: Over or under tightening the knock sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control. Always use the specified torque when installing the knock sensors.

NOTE: Note foam strip on bolt threads. This foam is used only to retain the bolts to sensors for plant assembly. It is not used as a sealant. Do not apply any adhesive, sealant or thread locking compound to these bolts.

Courtesy of CHRYSLER GROUP, LLC
Position the knock sensor, install the retaining bolt (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
Connect the wire harness connector (5).