LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 3500 Van Cargo Extended >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Fan, Cooling >> Removal

Fan, Cooling: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the right tire and wheel assembly. Refer to REMOVAL .
  3. Remove the right lower splash shield.
  4. Remove the nut cooling fan ground wire from the left frame rail.
  5. Remove the three retainers securing the coolant hose to the cooling fan and position aside the coolant hose.
  6. Drain the cooling system. Refer to DRAINING  .
  7. Remove the air cleaner resonator. Refer to RESONATOR, AIR CLEANER, REMOVAL .
  8. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
    GC0157472Courtesy of CHRYSLER GROUP, LLC
  9. Remove the pressurized coolant bottle bolt (6) and position aside the pressurized coolant bottle (3).
  10. Detach the wire harness retainers from the pressurized coolant bottle.
  11. Remove the pressurized coolant bottle bracket bolts and the pressurized coolant bottle bracket.
  12. Remove the nuts and the Power Distribution Center (PDC) cover.
  13. Lift the PDC and turn over to access the back side.
  14. Disconnect the two cooling fan wire harness connectors from the PDC and position aside.
    GC0157476Courtesy of CHRYSLER GROUP, LLC
  15. Disconnect the upper radiator hose (3) from the radiator and position aside.
  16. Remove the grille. Refer to GRILLE, REMOVAL .
    GC0160444Courtesy of CHRYSLER GROUP, LLC
  17. Remove the side fasteners (1) and upper fasteners (2, 3) from the front fascia and reposition the front fascia.
    GC0160600Courtesy of CHRYSLER GROUP, LLC
  18. Remove the radiator support bolts (2).
  19. Remove the four front fasteners (3).
  20. Remove the top fasteners (1) and position aside the radiator crossmember.
    GC0145992Courtesy of CHRYSLER GROUP, LLC
  21. Release the retaining clips (2) and lifting upwards to release the cooling fan (3) from the mounts.
  22. Remove the cooling fan (3) from the top of the vehicle.
    GC0160702Courtesy of CHRYSLER GROUP, LLC
  23. If required, disconnect the cooling fan relays wire harness connector (1), the resistors (2) and the cooling fan motors (3).
    GC0160412Courtesy of CHRYSLER GROUP, LLC
  24. If required, separate the wire harness (1) from the cooling fan shroud.
scientia non olet · About LEMON Manuals