Section 17 (Charging System (Service Information)): Generator: Removal: 6.2L
WARNING: This page is about a different car, the 2020 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disconnect the negative battery cable before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage the electrical system.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the belly pan. Refer to BELLY PAN, ENGINE, REMOVAL
.
- Depress the field wire connector tab (1) at the rear of the generator and disconnect the field wire harness connector.
- Remove the insulator cover (2) from B+ output terminal at the rear of the generator.
- Remove the B+ terminal retaining nut (3) at the rear of the generator and remove the B+ terminal.
- Unsnap the plastic insulator cap from B+ output terminal at the rear of the generator.
- Remove the B+ terminal retaining nut at the rear of the generator and remove the B+ terminal.
- Depress the field wire connector tab at the rear of the generator and disconnect the field wire connector.
- Remove the lower generator retaining bolt (1).
- Remove the support and lower the vehicle.
- Remove the upper generator retaining bolts (1) and remove the generator from the vehicle.