LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2021 >> ProMaster City Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.4L Engine (Service Information) >> Engine Block >> Frame, Ladder >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Remove the engine from the vehicle and mount the engine in the maintenance stand. Refer to REMOVAL AND INSTALLATION .
  2. Remove the rear crankshaft oil seal. Refer to SEAL, CRANKSHAFT OIL, REAR, REMOVAL AND INSTALLATION .
  3. Drain the engine oil. Refer to OIL, STANDARD PROCEDURE .
    GC0169919Courtesy of CHRYSLER GROUP, LLC
  4. Using a suitable oil filter wrench, remove the oil filter (1).
    GC0169964Courtesy of CHRYSLER GROUP, LLC
  5. Remove the three bolts (5) and the oil cooler heat shield (4).
    GC0102781Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Typical oil cooler shown in illustration

  6. Remove the oil cooler connector bolt (2) and reposition the oil cooler.
  7. Remove and discard the oil cooler seal (1).
    GC0156074Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the B+ cable (2) and the field generator harness connector (3) from the generator.
  9. Remove the bolts (1, 4) and the generator from the engine.
    GC0169172Courtesy of CHRYSLER GROUP, LLC
  10. Remove the bolt (2) and the dipstick tube (1).
    GC0169955Courtesy of CHRYSLER GROUP, LLC
  11. Remove and discard the dipstick tube O-ring seal (1).
    GC0169358Courtesy of CHRYSLER GROUP, LLC
    12. NOTE:

    Leave the accessory belt tensioner (3) attached to the generator mounting bracket (1).

  12. Remove the three bolts (2) and the generator mounting bracket (1) from the engine.
    GC0156353Courtesy of CHRYSLER GROUP, LLC
  13. Remove the bolt (2), two nuts (1) and the lower intake manifold support bracket (3).
    GC0169431Courtesy of CHRYSLER GROUP, LLC
  14. Remove the three bolts (2) and the intermediate shaft bearing housing (1) from the engine, if equipped.
  15. Remove the cylinder head cover, oil pan and engine timing cover. Refer to COVER(S), ENGINE TIMING, REMOVAL AND INSTALLATION .
  16. Remove the balance shaft/oil pump assembly. Refer to PUMP, ENGINE OIL, REMOVAL AND INSTALLATION .
    GC0121277Courtesy of CHRYSLER GROUP, LLC
  17. Remove the ladder frame bolts in reverse of the sequence shown in illustration.
    GC0121274Courtesy of CHRYSLER GROUP, LLC
  18. Separate the ladder frame from the engine block using the pry point cast in the rear of the engine block (1).
    GC0121275Courtesy of CHRYSLER GROUP, LLC
  19. Separate and remove the ladder frame from the engine block using another pry point (1) cast in the right side of the engine block.
scientia non olet · About LEMON Manuals