Removal And Installation: Installation
- Apply clean engine oil to the vibration damper bolt threads and between the bolt head and washer.
- Install the vibration damper and vibration damper bolt. Use (special tool #9707, Holder, Vibration Damper) (1) and tighten the bolt to the proper torque specification
Refer to TORQUE SPECIFICATIONS .
- Install the accessory drive belt (3) by positioning the belt over all of the pulleys with the exception of the tensioner pulley (1).CAUTION:
Do not let the tensioner arm snapback to the fully extended position, severe damage may occur to the tensioner.
- Rotate the center bolt of the tensioner pulley (1) counterclockwise, install the accessory drive belt (3) on the tensioner pulley (1) and slowly release the tensioner.
- Visually inspect the belt to pulley alignment.
- Engage the tube retainer (2) to the power steering line (3) and install two nuts (1) tightened to the proper torque specification. Refer to SPECIFICATIONS
.
- Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
- Install the right lower splash shield (1) with four bolts (3, 4) and screw (2) tightened to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
- Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
- Start the engine and allow to run at idle momentarily. Shut the engine off and reinspect the belt alignment.