Insulator, Engine Mount, Left: Removal
- If required, raise the vehicle to remove the belly pan.
- Disconnect and isolate the negative battery cable.
- Carefully position a floor jack under transmission to support the transmission.
- Remove the nut (2) from the through stud.
- Remove the upper transmission mount upper nuts (2).
- Using care, lower the trans jack enough to gain access to the upper transmission mount lower bolts (3).CAUTION:
Do not reuse fasteners. Reusing fasteners and not installing new fasteners tightened to the proper torque specifications may lead to catastrophic failure.
- If required, remove the lower engine mount bracket (3) and discard the fasteners (1, 2). New fasteners must be used upon installation.