Sensor, Crankshaft Position: Removal

Courtesy of CHRYSLER GROUP, LLC

The crankshaft position (CKP) sensor is mounted into the right rear side of the cylinder block.

1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
3. Push back the heatshield (1) from the crankshaft position (CKP) sensor.

   Courtesy of CHRYSLER GROUP, LLC

4. Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.

   Courtesy of CHRYSLER GROUP, LLC

5. Remove the sensor mounting bolt (2).
6. Carefully twist the sensor (1) from the cylinder block.

   Courtesy of CHRYSLER GROUP, LLC

7. The CKP sensor O-ring (1) can be reused if not damaged.