Charging System (Service Information): Generator: Installation: 5.7L
- Install the mounting bolts (1). The lower mounting bolt goes in the rear mounting hole.
- Install the lower stud bolt (2) in the lower front mounting hole. Torque the bolts to the proper torque specification. Refer to TORQUE SPECIFICATION .
- Install the Ground wire on the lower mounting stud (2) and install the ground wire mounting nut finger tight and tighten to the proper torque specification. Refer to TORQUE SPECIFICATION .
- Snap the field wire connector (3) into the rear of the generator.
- Install the B+ terminal eyelet to the generator output stud.
Tighten the mounting nut to the proper torque specification. Refer to TORQUE SPECIFICATION .
CAUTION:Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
CAUTION:When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or Refer to the Belt Schematics in 5.7L/6.4L .
- Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Install the air cleaner body. Refer to INSTALLATION .
- Install the negative battery cable and tighten the nut to the proper torque specification. Refer to TORQUE SPECIFICATIONS .