LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Cooling System) >> Engine >> Pump, Water >> Installation >> 5.7L/6.4L

Pump, Water: Installation: 5.7L/6.4L

WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the mating surfaces of the timing chain cover and the water pump.
    GC0137090Courtesy of CHRYSLER GROUP, LLC
  2. Install the water pump (3) and tighten the bolts (6) to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
  3. Install the upper stud bolt (2) and tighten the bolt to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
  4. Install the lower radiator hose to the water pump.
  5. Install the upper radiator hose to the thermostat housing (1).
  6. Install the belt tensioner assembly (4) and tighten the bolt to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
  7. Install the idler pulley (5) and tighten the bolt to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
    GC0144611Courtesy of CHRYSLER GROUP, LLC
  8. Connect the temperature sensor wire hire harness connector (2).
  9. Using a NEW  O-ring seal, install the heater tube (3) and tighten the bolt (1) to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
  10. Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
  11. Install the cooling fan assembly. Refer to FAN, COOLING, INSTALLATION .
  12. Install the air cleaner body. Refer to INSTALLATION BODY, AIR CLEANER, INSTALLATION .
  13. Connect the negative battery cable.
  14. Evacuate the air and refill cooling system. Refer to STANDARD PROCEDURE .
  15. Check the cooling system for leaks. Refer to DIAGNOSIS AND TESTING .
scientia non olet · About LEMON Manuals