5.7/6.4L Single Fan

WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If replacing the fan blades. The dual fan blades can be replaced separately from the motor. Single motor fan blades are balanced to the motor and must be replaced as a fan/motor assembly.

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

When installing the cooling fan assembly, care must be used so that the fan shroud does not contact the radiator or the radiator fins. Damage may cause leaking.

Install the radiator cooling fan assembly in vehicle.
Align the lower cooling fan assembly mounting tabs (1) with the radiator mounts (2).
Tighten the lower radiator support bolts to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
Install the lower engine belly pan. Refer to BELLY PAN, INSTALLATION .
Remove support and lower vehicle.

Courtesy of CHRYSLER GROUP, LLC
Install the cooling fan assembly mounting bolts (3). Tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS GAS .
Connect cooling fan wire harness connector (1).
Install the air cleaner body. Refer to INSTALLATION BODY, AIR CLEANER, INSTALLATION .
Connect the negative battery cable.
Operate engine until it reaches normal operating temperature. Check the fan for proper operation.