LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Fuel System) >> Fuel Injection, Gas >> Sensor, Air Temperature, Inlet >> Installation >> 3.6L

Sensor, Air Temperature, Inlet: Installation: 3.6L

WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
GC0082921Courtesy of CHRYSLER GROUP, LLC
  1. The Inlet Air Temperature (IAT) sensor O-ring seal (2) can be reused if not damaged.
  2. Clean the IAT sensor mounting hole in the air inlet hose.
  3. Install the IAT sensor into the air inlet hose and rotate clockwise until the release tab (3) engages.
    GC0144242Courtesy of CHRYSLER GROUP, LLC
  4. Install the IAT sensor wire harness connector (1).
    GC0144028Courtesy of CHRYSLER GROUP, LLC
  5. Install the engine cover (1).
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals