Charging System (Service Information): Generator: Removal: 5.7L/6.4L
WARNING:
Disconnect the negative battery cable before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage the electrical system.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.CAUTION:
Do not let the tensioner arm snap back to the freearm position, severe damage may occur to the tensioner.
- Rotate the accessory drive belt tensioner clockwise until it contacts the stop and remove the accessory drive belt, then slowly rotate the tensioner into the free position.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the belly pan. Refer to BELLY PAN, ENGINE, REMOVAL .
- Disconnect the generator field wire harness connector.
- Remove the insulator cover from B(+) output terminal at the rear of the generator.
- Remove the B(+) terminal retaining nut and remove the B(+) terminal.
- Remove the generator support bracket to engine mount retaining nut (1).
- Remove the generator support bracket retaining bolt (2) and remove the support bracket (3).
- Remove the lower generator retaining bolt (1).
- Remove the support and lower the vehicle.
- Remove the upper generator retaining bolt (1) and remove the generator (2) from the vehicle.