Removal And Installation: Installation

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Right side shown in illustration, left side similar.

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Install the radiator fan shroud from the bottom of the vehicle.
Place the radiator fan shroud into the radiator mounts (2) and engage the retainers (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the support and lower the vehicle.
Engage the transmission oil cooler line retainer (1) to the radiator fan shroud.
Connect and lock the radiator cooling fan harness connector (4).
Connect and lock the radiator cooling fan speed control module harness connector (3).
Engage the wire harness retainer (2) to the fan shroud.

Courtesy of CHRYSLER GROUP, LLC
Position the pressurized coolant bottle (1) onto the rubber grommet.
Install the two bolts (2) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Position the core support (4), while aligning the radiator to the bushings (1) and install the two lower bolts (3) hand tight.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown in illustration, right side similar.
Install the bolts (1) to hold the front of the right and left load beams to the radiator support panel and tighten the bolts to the proper specification. Refer to TORQUE SPECIFICATIONS .
Tighten the two previously installed lower radiator core support bolts to the proper specification. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Install the right lower splash shield (1) with four bolts (3 and 4) and screw (2) tightened to the proper specification. Refer to TORQUE SPECIFICATIONS .
Install the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.