LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Journey Crossroad >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Security Gateway (SGW) >> Installation

Module, Security Gateway (SGW): Installation

NOTE:

If a NEW  Security Gateway (SGW) module is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

  1. Position the SGW module to the mounting studs.
    GC0183890Courtesy of CHRYSLER GROUP, LLC
  2. Install the SGW module fasteners (1) and tighten securely.
  3. Connect the SGW module wire harness connectors (2).
  4. Install the driver side kneeblocker. Refer to KNEEBLOCKER, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. If a NEW  SGW module is installed, use the diagnostic scan tool to flash the SGW module.
scientia non olet · About LEMON Manuals