LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Journey Crossroad >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Keyless Ignition Node (Kin) >> Removal

Module, Keyless Ignition Node (Kin): Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the switch-bank and bezel assembly. Refer to POD, SWITCH BANK, REMOVAL .
  3. Remove the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
    GC0147718Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connector (1) from the Keyless Ignition Node (KIN).
  5. Push down on the release clips (2) and push the KIN (3) out the front of the instrument panel.
scientia non olet · About LEMON Manuals