Radiator, Engine Cooling: Installation: 5.7L/6.4L
- Install the radiator into the engine compartment and seat the lower rubber isolators into the mounting holes in the radiator lower support.
- Install the upper shroud cover (2) by applying downward pressure until the clip snaps into place.
- Position the condenser on the radiator and loosely install the right side upper mounting bolt. Tighten the bolt to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the lower mounting bolts and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the bolt (2) located between the cooler lines and securely tighten.
- Install the upper radiator isolator (1) and tighten the bolts (2) to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the front bumper fascia. Refer to FASCIA, FRONT, INSTALLATION .
- Install the radiator fan. Refer to FAN, COOLING, INSTALLATION .
- Install the lower radiator hose (1).
- Install the belly pan and tighten the bolts (1) securely.
- Remove the support and lower the vehicle.
- Install the upper radiator hose.
- Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
- Fill the cooling system with coolant. Refer to STANDARD PROCEDURE .
- Connect the negative battery cable.
- Operate the engine until it reaches normal operating temperature. Check the cooling system and automatic transmission for the correct fluid levels.