LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2019 >> ProMaster 2500 >> Repair and Diagnosis >> Engine Performance >> Ignition System (Service Information) >> Solenoid, Variable Valve Timing >> Removal >> Right

Solenoid, Variable Valve Timing: Removal: Right

GC0129313Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the resonator. Refer to RESONATOR, AIR CLEANER, REMOVAL .
  4. Remove the upper A/C liquid and suction line assembly (1). Refer to LINE, A/C SUCTION, REMOVAL .
    GC0144211Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Mark the Variable Valve Timing (VVT) solenoid connectors (1) with a paint pen or equivalent so that they may be installed in their original locations.

  5. Mark the intake VVT solenoid (2) and the exhaust VVT solenoid (4) with a paint pen or equivalent so that they may be installed in their original locations.
  6. Disconnect the wiring harness connector (1) from the VVT solenoid.
  7. Remove the VVT solenoid mounting bolts (3).
    GC0144209Courtesy of CHRYSLER GROUP, LLC
  8. Pull the VVT solenoid from the cylinder head cover.
    NOTE:

    The seal (1) can be reused if it is not damaged.

scientia non olet · About LEMON Manuals