Module, Radio Frequency (RF Hub): Installation
- Position the Remote Frequency Hub (RF-Hub) into the vehicle and install the fasteners (1). Tighten the fasteners securely.
- Connect the wire harness connectors to the RF-Hub.
- If equipped, connect the Remote Start Antenna (RSA) (3).
- Install the rear shelf trim panel. Refer to PANEL, REAR SHELF, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
Program the RF-Hub in accordance with the module replacement and programming guide. Refer to RF-HUB PROGRAMMING .