Pipe, Exhaust: Installation: Notes
| 1 - EXHAUST PIPE |
| 2 - NUTS |
| 3 - CROSS UNDER PIPE |
| 4 - GASKET |
- Position exhaust pipe (1) into muffler/resonator assembly.
- Position exhaust pipe onto cross over pipe.
- Install exhaust pipe (1) to cross over pipe nuts. Tighten to 28 N.m (250 in. lbs.).
- Align exhaust pipe (1) and resonator/muffler pipe assembly to maintain position and proper clearance with underbody parts. All support isolators should have equal load on them. Tighten fasteners attaching exhaust pipe (1) to cross-under pipe (3) to 28 N.m (21 ft. lbs.).
- Install new band clamp. Tighten band clamp to 54 N.m (40 ft. lbs.).
- Lower vehicle.
- Connect the negative battery cable.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary. Refer to LEAK TESTING .
- Check the exhaust system for contact with the body panels. Make the necessary adjustments, if needed.