Insulator, Engine Mount, Front: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect and isolate the negative battery cable.
Remove the supercharger assembly. Refer to SUPERCHARGER, REMOVAL .
Remove the engine oil dipstick tube retaining nut at the right exhaust manifold.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Remove the belly pan retainers (1) and remove the belly pan.

Courtesy of CHRYSLER GROUP, LLC
Remove both left/right engine mount heat shield (4) retaining nuts (3) and remove the heat shields
Remove both left/right engine mount lower retaining bolts (2).
Lower the vehicle.
Remove the Variable Valve Timing Solenoid (VVTS)
Refer to SOLENOID, VARIABLE VALVE TIMING (VVTS), EXHAUST, REMOVAL .

NOTE:
Do not use air tools to install the engine lift fixture.

Courtesy of CHRYSLER GROUP, LLC
Install the Engine Lift Fixture (special tool #8984B, Fixture, Engine Lifting) (1), Engine Lift Adapter (special tool #8984-UPD, Adapter, Engine Lift) (3) and the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support) (2).
Raise the engine to provide clearance to remove the engine mounts.
Raise and support the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Remove the generator support bracket to engine mount retaining nut (1).
Remove the generator support bracket retaining bolt (2) and remove the support bracket (3).

Courtesy of CHRYSLER GROUP, LLC
Remove both left/right engine mount retaining bolts (1) and remove the engine mounts (2).

Courtesy of CHRYSLER GROUP, LLC
If necessary, remove both engine mount to engine block mounting bracket retaining bolts (1) and remove the mounting brackets (2).