Link, Stabilizer Bar: Installation
- Install stabilizer bar link (4) into mounting hole on lower control arm (3) and install nut (2). Do not tighten at this time.
- Install end of stabilizer bar (5) onto stabilizer bar link (4) and install nut (1). Do not tighten at this time. .
- Install wheel and tire assembly. Refer to INSTALLATION .
- Lower vehicle.
- Position vehicle on alignment rack/drive-on hoist.NOTE:
On models equipped with six piston calipers the calipers need to be unbolted from the knuckle and hung out of the way so that the suspension height stands can be installed correctly.
- Remove tire and wheels assemblies and install (special tool #9096, Height Stands, Suspension) (1) onto the hub and bearing assembly (2) and tighten to the proper specifications. Refer to SPECIFICATIONS .
- Tighten stabilizer link to lower control arm nut to the proper specifications. Refer to FRONT, SPECIFICATIONS .
- Tighten stabilizer link to stabilizer bar nut to the proper specifications. Refer to FRONT, SPECIFICATIONS .NOTE:
On models equipped with six piston calipers the calipers need to be reinstalled onto the knuckle and tighten the two mounting bolts to the proper specifications. Refer to SPECIFICATIONS .
- Remove the special tool and install the tire and wheel assemblies. Refer to INSTALLATION .
- Lower vehicle.