Toe Pattern Preparation

Before toe pattern can be inspected, vehicle Curb Height, suspension settings and design bushing position must be established.

1. Verify that all fluid reservoirs and fuel tank is full.
2. Position the vehicle on a known level surface (suspension or frame alignment rack).
3. Remove all objects from the vehicle that were not installed at the assembly plant.
4. Inflate tires to the specification found on the tire inflation sticker (placard) on the left door end frame.
5. Place vehicle on wheel alignment rack/hoist.
6. Verify vehicle curb height, caster, and camber are within specifications and toe is set to Preferred Specifications. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .