Sending Unit And Sensor, Fuel Level: Removal

Courtesy of CHRYSLER GROUP, LLC

1. Remove fuel pump module. Refer to MODULE, FUEL PUMP, REMOVAL .

   Courtesy of CHRYSLER GROUP, LLC

2. Push down on the tab (3) and slide fuel level sensor (1) down and off of the channel on the housing of the pump module.
3. Remove the fuel level sensor wires from the retaining tab (2) on the housing.

   Courtesy of CHRYSLER GROUP, LLC

4. Disconnect fuel pump/level sensor connector (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Pull out the locking wedge.

   Courtesy of CHRYSLER GROUP, LLC

   1 - LOCKING FINGER

   2 - WIRE TERMINAL

6. Using a small screwdriver lift locking finger (1) away from terminal (2) and push terminal out of connector. Remove the fuel level sensor signal and ground terminals out of the connector.