Pedal, Accelerator: Installation

The Accelerator Pedal Position Sensor (APPS) and the accelerator pedal is serviced as a complete assembly including the bracket.

Courtesy of CHRYSLER GROUP, LLC

1. Install the accelerator pedal assembly on the two mounting studs (1). Tighten nuts (4) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
2. Connect the APPS (6) wire harness connector (3).
3. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
4. Connect the negative battery cable.
5. Use a scan tool to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
6. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
7. If necessary, also use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from the PCM.
8. Before starting the engine, operate the accelerator pedal to check for any binding.