LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2016 >> Viper GTC >> Repair and Diagnosis >> External Pages >> Different car >> Section 137 (Electronic Control Modules (Service Information)) >> Module, Electronic Steering Lock (ESL) >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2016 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the electronic steering lock module is not damaged.
  2. Connect the electrical connection.
  3. Place the electronic steering lock module in its housing and tighten the new special screws until the head shears off.
  4. Connect the steering column stalk electrical connection and reposition the wiring.
  5. Install the steering column shroud. Refer to SHROUD, STEERING COLUMN, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable.
  7. Perform module programming as needed. Refer to MODULE, ELECTRONIC STEERING LOCK (ESL), MODULE PROGRAMMING  for further information.
scientia non olet · About LEMON Manuals