LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2016 >> Viper Base >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> Front >> Hub And Bearing >> Installation

Hub And Bearing: Installation

GC0135000Courtesy of CHRYSLER GROUP, LLC
CAUTION:

A special corrosion prevention gasket (1) must be installed between the hub and bearing and the steering knuckle. The gasket is required to prevent galvanic corrosion between the hub and bearing and the steering knuckle.

  1. Install a new corrosion prevention gasket (1) on hub and bearing mounting flange (2).
    GC0134999Courtesy of CHRYSLER GROUP, LLC
  2. Install hub and bearing (with gasket) in steering knuckle (1). Align holes in corrosion prevention gasket with holes in hub and bearing, and knuckle.
  3. Install four hub and bearing mounting bolts (3) and tighten mounting bolts to the proper specifications. Refer to FRONT, SPECIFICATIONS .
    GC0134998Courtesy of CHRYSLER GROUP, LLC
  4. Install ABS wheel speed sensor tone wheel (4) and tighten mounting bolt (4) to the proper specifications. Refer to ANTILOCK BRAKE SYSTEM FASTENER TORQUE .
    GC0134982Courtesy of CHRYSLER GROUP, LLC
  5. Install ABS wheel speed sensor head (2) on knuckle (1). Tighten mounting bolt (3) to the proper specifications. Refer to ANTILOCK BRAKE SYSTEM FASTENER TORQUE .
  6. Install brake rotor, then caliper. Refer to ROTOR, BRAKE, INSTALLATION .
  7. Install wheel and tire assembly. Refer to INSTALLATION .
  8. Lower vehicle.
scientia non olet · About LEMON Manuals